Top > INSTALLATION > Connecting the Water Supply Hose > Note for Connection

Note for Connection

  • Water pressure must be between 100 kPa and 800 kPa (1.0 – 8.0 kgf/cm²). If the water pressure is more than 800 kPa, a decompression device should be installed.

  • Periodically check the condition of the water supply hose and replace the water supply hose if necessary.

Note
  • If the water pressure is near or over 800 kPa, a water pressure reduction device should be installed to both taps.

  • Exceeding 65 °C can damage some clothes.

  • Temperatures below 4 °C can cause hoses to freeze and burst and unfavourable wash results due to undissolved detergent.

  • Cold inlet Water Temperatures over 25 °C can cause damage to clothes such as delicate Woollens

  • Do not overtighten the water supply hose or use mechanical devices to tighten onto the inlet valves.

  • No further backflow protection required for connection to the water inlet.

  • Ensure the inlet hoses are not bent, kinked or tangled as this could cause insufficient water flow and result in a malfunction.